4
MOUNTING THE FITTING
To ensure correct operation of the sensor, mount the fitting where traffic passes across the detector.
SETTING THE LIGHT UP TIME & SENSITIVTY
Remove the back mounting box from the fixture by unscrewing the screw at the bottom.
Set the Light up time & Sensitivity you
preferred
１ ：
Light up time (OFF
：
30 seconds
／
ON
：
60 seconds)
２ ：
Sensitivity (OFF
：
5m
／
ON
：
10m)
Re-fit the back mounting box and tighten the screw.
WIRING INSTRUCTIONS
Feed the cable through the back mounting box
and bush the cable entry to avoid abrasion to
the cable.
Connect the earth wire to the connector
opposite the green/yellow cable.
Connect the brown phase conductor active to
the connector opposite the brown cable and
tighten the screws.
Connect the blue neutral conductor to the
connector opposite the blue cable and tighten
the screws.
Check that all connections are correct and tight, as any misconnections will damage the detector.
Re-fit the fitting to the back mounting box.
TOP VIEW
GOOD SENSITIVITY
LESS SENSITIVITY
