4.
Make sure the polarity is correct. Double check the connections after wiring. Errors may damage the
motion sensor or cause a fire hazard.
5.
Attach the unit to the mounting plate. You will first need to angle the unit back so that the catch at the
top of the mounting plate fits into slot on the back of the unit. Next lower the unit until holes at the
bottom of the mounting plate and unit are flush. Then screw (screw A) into this hole, tightening
carefully.
Please allow 1 minute warm-up time after switching on.
* Push the RESET button after switching on.
Remove plastic lens cover from camera after installation
. (see fig. 7)
Fig. 7
Fig.6
