SD210 Series
Operating & Safety Instructions
English/USA – 07/11
Issue 06
10
2.1.9
Never position any part of the Niftylift within 4.0m, (12ft) of any electrical power line, conductor or
similar not exceeding 66kV. (Minimum span 125m) Other distances for increased voltages and
different spans are given in NZECP 34:1993.
THIS MACHINE IS NOT INSULATED.
If in doubt, contact the appropriate authorities.
2.1.10
On entering the platform ensure that the sliding midrail is fully down in its correct “closed” position.
2.1.11
Use of an approved safety belt and lanyard, hardhat and appropriate safety clothing is strongly
recommended for operator safety. Fasten harness to designated harness securing points within the
platform and do not remove until leaving the platform whilst in the stowed position.
Always remain standing within the platform. Do not attempt to increase your height or
reach by standing and/or climbing on the platform guardrails or any other object.
KEEP YOUR FEET ON THE PLATFORM FLOOR.
Do not sit, stand or climb on the
guardrail, mid rail or boom linkage. Use of planks, ladders or any other devices on the
Niftylift for achieving additional height or reach is prohibited.
2.1.12
Do not use the platform levelling system to artificially increase the outreach of the platform. Never use
boards or ladders in the platform to achieve the same result.
2.1.13
Do not use the platform to lift overhanging or bulky items that may exceed the maximum capacity or
carry objects that may increase the wind loading on the platform. (e.g. Notice boards etc.)
2.1.14
The Niftylift shall not be operated from a position on trucks, trailers, railway cars, floating vessels,
scaffolds or similar equipment unless Niftylift Ltd in Great Britain approves the application in writing.
2.1.15
Always check below and around the platform before lowering or slewing to ensure that the area is clear
of personnel and obstructions. Care should be taken when slewing out into areas where there may be
passing traffic. Use barriers to control traffic flow or prevent access to the machine.
2.1.16
Stunt driving or horseplay, on or around the Niftylift, shall not be permitted.
2.1.17
When other moving equipment and vehicles are present, special precautions shall be taken to comply
with local ordinances or safety standards established for the work place. Warnings such as, but not
limited to, flags, roped off areas, flashing lights and barricades shall be used.
2.1.18
Under all travel conditions the operator shall limit travel speed according to conditions of ground
surface, congestion, visibility, slope, location of personnel and other factors causing hazards of
collision or injury to personnel.
2.1.19
The aerial platform shall not be driven on grades, side slopes or ramps exceeding those for which the
manufacturer rates the aerial platform.
2.1.20
It shall be the responsibility of the user to determine the hazard classification of any particular
atmosphere or location. Aerial platforms operated in hazardous locations shall be approved and of the
type required. (For the USA refer to ANSI/NFPA 505-1987.)
2.1.21
The operator shall immediately report to his supervisor any potentially hazardous location(s)
(environment) which become evident during operation.
