Rev. 0 - 05/11/2020
OPERATING MANUAL
OPERATING MANUAL
EN
EN
25/48
9.6.4.5 +24V AUX Power supply (for PFP 3-Ph only)
The +24V output can supply a max current of 50mA and it is able to drive the
Nicotra Gebhardt
pressure transducer (code K43198).
Use an available ground pin on the board for powering devices.
If the transducer has its own PID control, the signal must be connected to the standard ANALOG INPUT.
9.6.4.6 Relay (for PFP 3-Ph only)
A relay is available on the Three-Phase drivers.
It is suitable for 250Vac/30Vdc 5A.
When the driver is powered off the relay is open -> the PCB label indicates C-NO.
During the functioning the relay is Normally Closed in No-Alarm condition and open in case of alarm.
For details concerning the Volumeter measurement system for the volume flow rate, please refer
to paragraph 11.
Min. and max. section:
• 0.33 - 2 mm
2
(22 - 14 AWG) solid or stranded cable.
