Page 17
Reverse Joystick Movement/DMX Channel
-
Enable Programming Mode.
-
Press the Fine and Mode buttons to enter assign mode, then press Fine and Mode buttons again to enter reverse
mode. The reverse LED lights up indicating reverse mode is active.
-
Use Bank Up/Down button to change between the Pan and Tilt, the corresponding LED lights indicating this
selection.
-
Press the Tap/Display button to change between 8 CHANNEL and 16 CHANNEL mode.
-
Press the scanner buttonto select the scanner.
-
While holding the mode button, press the corresponding scene button the channel you wish to reverse. (For
Example: If you are reversing the on one scanner, once you verify that you are in reverse mode, and the Tilt LED is
lit, check to see which slider the Tilt control is on. Hold the mode button and press the scene button that is same as
the slider number for tilt. (Slider 5/Scene 5).
-
Continue steps 3-7 as needed. You may reverse a maximum of 48 channels for 12 scanners.
Delete a scanner of DMX Channels
-
Activate Assign or reverse mode.
-
Tap the scanner button to select the scanner you wish to delete.
-
Press the mode and Auto/Del buttons at the same time. All LEDs will flash three time indicating the requested
operation has been performed.
Clear All DMX Channels
-
Turn the power to the unit off.
-
Press the Mode and Auto/Del buttons at the same time.
-
While holding the two buttons, turn the power back on to the unit. All LEDs will flash briefly indicating the requested
operation has been performed.
Display DMX Channel
-
Press the Fine and Mode buttons at the same time, putting the controller into assign mode.
-
Press the Fine and Mode buttons again, lighting the reverse LED.
-
Press the scanner button that is set at the desired Pan and Tilt and the LCD will display the DMX values for Pan and
Tilt.
FADE TIME
Fade Time/Assign Fade Time
-
With the power off, press the mode and Tap/Display buttons at the same time.
-
Apply the power again, tap the Tap/Display button to change between Fade Time and Assign Fade Time, the LCD
reads
ALL
ONLY
FD
FD
CH
X/Y
OR
TIME
TIME
-
Press the Mode and Tap/Display buttons at the same time to store your setting into memory. If you do not wish to
save your setting, press the blackout key to exit this operation.
PLAYBACK
Running Scenes
Threr are three modes in which you can run scenes and chases. They are Manual mode, Auto mode, and music mode.
