Page 16
-
Enable Programming Mode.
-
Tap the Chase button to select the chase you wish to program.
-
Select a desired scene from the bank that has scenes stored inside it.
-
Tap the MIDI/Rec button.
-
Repeat steps 3-4 until all desired scenes scenes have been entered.
Inserting a bank of scenes into a chase
-
Enable Programming Mode.
-
Select the chase you wish to program.
-
Use the Bank Up/Down key to select the bank of scenes you wish to copy.
-
Tap the Music/Bank Copy button.
-
Tap the MIDI/Rec copy button, all LEDs will flash three times indicating that the requested operation has been
performed.
Add A Step
-
Enable Programming Mode.
-
Press the corresponding button to the chase you wish to add a step to.
-
Press the Tap/Display button, the LCD will show the current step.
-
Press the Bank Up/Down button and scroll to the step you wish to insert the step after.
-
Press the MIDI/Rec button, the segment display will read the step one step higher than before.
-
Tap the Tap/Display buttonagain. The LCD shows the current chase, scene, and bank. Create a desired scene and
record it as a new step or select a previously programmed scene to add to the chase.
-
Once you have selected the scene you wish to add, press the MIDI/Rec button again. All LEDs will flash three time
indicating the new step has been inserted into the chase.
Deleting A Step
-
Enable Programming Mode.
-
Select the chase that contains the step you wish to delete.
-
Press the Tap/Display button, the LCD shows the current step.
-
Press the Bank Up/Down button and scroll to the step you wish to delect.
-
Press the Auto/Del button to delete the step. All LEDs will flash three times indicating the requested operation has
been performed.
Delete A Chase
-
Press the button corresponding to the chase you wish to delete.
-
Press and hold down the Auto/Del button while holding down the chase button. All LEDs will flash three time
indicating that the requested operation has been performed.
Delete All Chases
-
With the power off, press and hold down the Auto/Del and Bank Down buttons at the same time.
-
Reapply the power, and all chases should be cleared.
JOYSTICK/CHANNEL SELECTION
Set-up Joystick
-
Press and hold the “Program” button until LED is lit.
-
Press and hold the “Mode” and “Fine” buttons at the same time, the assign LED should light. If the reverse LED
lights, press “Fine” and “Mode” again to enter assign mode.
-
Use the bank Up and Down keys to select the axis you wish to assign (Pan or Tilt).
-
Use the “Tap/Display” button to select 16 or 8 channel mode.
-
Press the button corresponding to the scanner you wish to assign.
-
While holding the mode button press the scene number corresponding to the slider which controls the movement.
(Example: If pan is controlled by slider number 4, press and hold the “Mode” button while tapping scene button 4#).
-
When finished press the “Mode” and “Fine” button at the same time again to exit Assign mode.
