Page 15
-
Verify that the page select is set on page A, if not press the page select button to select page A.
-
Move the first and second faders all the way up to their maximum value position.
-
Select bank 1 using the bank Up/Down buttons.
-
Press the MIDI/Rec button.
-
Tap scene 1 to store the first scene.
-
Repeat steps 4-7 until all scenes have been programmed into bank 1.
-
Tap the scanner 1 button to turn off the fader control.
-
When finished, disable program mode. You can now manually tap through you have just programmed.
Editing A Scene
-
Program Enable.
-
Press the Bank Up/Down button to select the bank containing the scene you wish to edit.
-
Select the scene you wish to edit by tapping it’s scene button.
-
Use the faders and/or joystick to make the desired adjustments to the scene.
-
Once you have completed the changes, tap the MIDI/Rec button.
-
Tap the scene button that corresponds to the scene you’re editing. This will override the existing scene.
Be sure to select the same scene in steps 3 and 6, otherwise you may accidentally record over an existing scene.
Copy Scanner Settings – This setting allows you to copy the settings of one scanner to another
-
Press and hold down the scanner button you wish to copy.
-
While holding down the button, tap the button of the scanner you wish to copy the settings to.
Copy A Scene
-
Enable Program Mode.
-
Tap the Bank Up/Down button to select the bank containing the scene you wish to copy.
-
Select the scene you wish to copy by pressing it’s scene button.
-
Using the BankUp/Down button select the bank you wish to copy the scene to.
-
Tap the MIDI/Rec button.
-
Tap the scene button you wish to copy the scene to.
Deleting A Scene
-
Enable Programming Mode.
-
Press the desired Scene button to select the scene you wish to delete.
-
Press and hold down the Auto/Del button. While holding the button, tap the scene button that corresponds with the
scene you wish to delete.
-
When the programmed scene is delete, all DMX channel values will be set to 0.
Deleting All Scenes
-
With the power off to the unit, press and hold down the Program and Bank Down buttons at the same time.
-
Turn the unit back on, and all scenes should be cleared.
Copy A Bank of Scenes
-
Enable Programming Mode.
-
Tap the Bank Up/Down button until you reach the bank you wish to copy.
-
Tap the MIDI/Rec button.
-
Tap the Bank Up/Down button to select the bank you wish to copy to.
-
Tap the Music/Bank Copy button, all LEDs will briefly flash three times indicating the function has been completed.
-
Press the program button for three seconds to exit programming mode.
CHASES
Programming a Chase
Note: You must have already programmed scenes in order to program a chase, this function allows you to cycle through up
to 240 scenes in a preselected order. It is recommended before programming chases for the first time, you delete all
chases in the controller. See Delete All Chases for instructions on how to do so.
