Nice TITAN12L, Руководство пользователя

Страница: 12 / 36

12
www.hysecurity.com
4.3 Vehicular Horizontal Swing Gates
4.3.1 The following provisions shall apply to
Class I, Class II, and Class III horizontal swing
gates:
4.3.2 Gates shall be designed, constructed and
installed so as not to create an entrapment
area between the gate and the supporting
structure or other fixed object when the
gate moves toward the fully open position,
subject to the following provisions.
4.3.3 The width of an object (such as a wall, pillar
or column) covered by a swing gate when
in the open position shall not exceed 4 in.
(102 mm), measured from the centerline of
the pivot point of the gate. Exception: For
a gate that is not in compliance with this
provision, the defined area shall be subject
to the entrapment protection provisions of
UL 325.
4.3.4 Except for the zone specified in 4.3.3 the
distance between a fixed object such as
a wall, pillar or column, and a swing gate
when in the open position shall not be less
than 16 in. (406 mm). Exception: For a gate
that is not in compliance with this provision,
the defined area shall be subject to the
entrapment protection provisions of UL 325.
4.3.5 Class IV vehicular horizontal swing
gates shall be designed, constructed and
installed in accordance with security related
parameters specific to the application in
question.
5. Maintenance of Gate Systems
To keep your automated gate system performing
both safely and reliably it is important to ensure
that the components of that system are functioning
properly. At least monthly:
5.1 Disconnect the gate operator and manually
move the gate through its range of travel.
Note any squeaks from rollers or hinges or
areas of binding. The gate should travel
smoothly and quietly throughout its range.
If it does not, contact a gate professional to
correct the problem.
5.2 Reconnect the gate operator and perform the
following tests:
5.2.1 With the gate opening, block any photo
eyes and/or depress any safety edges used
to protect the open direction. The gate
should stop, or, stop and reverse.
5.2.2 With the gate closing, block any photo
eyes and/or depress any safety edges used
to protect the close direction. The gate
should stop, or, stop and reverse.
5.2.3 Using a suitable obstruction in the path of
the gate (a solid, immovable object), run the
gate in the open direction until it contacts
the obstruction. The gate should stop and
reverse.
5.2.4 Using a suitable obstruction in the path of
the gate (a solid, immovable object), run the
gate in the close direction until it contacts
the obstruction. The gate should stop, or,
stop and reverse.