English –
2
English
––– PHASE 2 –––
2.1 - PRODUCT DESCRIPTION AND APPLICATION
This kit consists of a tubular motor and various components, all exclu-
sively designed for automation of roller shutters.
Any other use is pro-
hibited! The manufacturer is not liable for damage resulting from
improper use of the product, other than that which is provided for
in this manual.
The tubular motor is formed mainly of a “motor” part, an electronic logic
which supplies the motor and controls execution of manoeuvres.
The tubular motor, through the use of adapters supplied for the purpose,
is installed by mounting it on the interior of the roller tube and the whole is
then affixed to the inside of the case (located above the roller shutter) us-
ing the supplied components.
The motor has command logic (integrated) with electronic limit switch
which halts movement of the roller shutter when the motor reaches the
following positions: the position when it completes the upward movement
(maximum opening: in the manual this is called “
limit switch 0
”) and the
position when it completes the downward movement (maximum closure:
in the manual this is called “
limit switch 1
”). The two limit switch points
are stored in the command logic with a simple programming procedure.
After limit switch programming, sending a command via the control trans-
mitter will activate the roller shutter movement, which will stop automati-
cally when the stored “limit switch point” has been reached.
2.2 - COMPONENTS CONTAINED IN THE KIT
Important!
– Before proceeding with the installation, it is necessary to
check the integrity of the components present in the
RMEKIT AXS 3017
kit and familiarise yourself with their names.
This kit includes the following
components (
fig. 2
):
[
a
] - Tubular motor (Ø 45 mm): code
RME 3017
[
b
] - 60 mm octagonal tube, 1 standard (
b1
) and 2 telescopic extensions
(
b2
,
b3
).
[
d
] - Transmitter to command the one shutter or a group of roller shut-
ters: code
STX100
.
[
e
] - Roller and its support (Ø 42 mm): code
525.10066
and
41.082
[
f
] - Motor head support with 4 special screws to fix the motor head:
code
525.10012/AX
.
[
g
] - Octagonal telescopic cap (60 mm): code
575.12260A
.
[
h
] - Small metal parts (screws, washers, etc.).
[
i
] - Motor adaptor set for 60 mm octagonal tube: code
515.06000
.
[
j
] - Six fasteners for roller shutter.
a
b
l
e
f
i
d
m
n
g
h
c
Push
STOP
a
b
l
e
f
i
d
m
n
g
h
c
Push
STOP
a
b
l
e
f
i
d
m
n
g
h
c
Push
STOP
2
PRODUCT FAMILIARISATION AND INSTALLATION PREPARATION
b1
b2
b3
code STX100
code 525.10012/AX
code 575.12260A
code 525.10066
code 41.082
code 515.06000
code RME 3017
