Nice E EDGE XSI 0620 LDC, Инструкции и предупреждения по установке и использованию

Страница: 19 / 24

English – 18
A.16 - Locking and unlocking the motor’s memory
NOTES AND WARNINGS
• Locking the motor’s memory stops any other (unscheduled or unauthorised) transmitters being memorised in it.
1 2 3

4
PRG
(x 1 )
2
PRG
(x 1 )
2
PRG
(x 1 )
3
Press and release
the button (
1 time );
count 2 movements. Press and release
the button (
1 time );
count 2 movements. Press and release
the button (
1 time );
count 3 movements.
4 5
...
= 5 sec
4
Select one of the following potions and execute it:
• option A – LOCK motor’s memory.
• option B
– UNLOCK motor’s memory.
Hold down both buttons... release them after
5 sec-
onds ;
count 4 movements.
option –
A
5
end
option –
B
5
end
= 5 sec
3
= 5 sec
5
Hold down the but-
tonand release it after 5
seconds ;
count 3 movements. Hold down the but-
tonand release it after 5
seconds ;
count 5 movements.
A
––– GROUP “B” PROCEDURES ––
Procedures run with the motor head buttons
B.1 - Precise adjustment of the UP (“0”) and DOWN (“1”) limit switch positions
NOTES AND WARNINGS
• This adjustment can be done at any time, on condition that the limit switch positions have already been programmed.
• The following procedure describes the setting of the Upper limit switch “0”.
To adjust the Lower limit switch “1”: (in step 1) command a DOWN movement (rather
than UP); (in step 2) adjust the height of limit switch “1” (instead of the height of limit switch “0”); (in step 3) as in the figure below.
1 2

3
Command
an UP
movement

(x
1
)
“
0
”
Adjust the po-
sition of limit
switch “0”.

“
0
”
Press and release the key. Wait for the move-
ment to finish at posi-
tion “0”. Press the buttons until you reach the desired position.
Note – Each step of the motor corresponds to a rotation
of around 2°.
3
end
= 5 sec
3
Hold down either of the two buttons; release it after
5 seconds
; count 3 movements.
B