Nice Apollo CBOX1K, Руководство пользователя

Страница: 14 / 48

14
While resting the front end of the gate operator on the gate
attachment bracket, slide the back end of the gate operator
onto the installed pivot bracket as shown. Insert the bolt,
washer, and locknut as shown in the diagram. Be careful
to not to over-tighten the locknut, but the bolt should be
sufficiently tightened to securely fasten the gate operator to
the pivot bracket.
Locate the top cover on the T5/T7 and remove the two
Phillips-head screws by rotating them counter-clockwise to
access the mounting hole and the wiring connectors. Be
careful to retain the screws and cover for reinstallation once
the T5/T7 is installed, the gate controller is programmed and
any other mechanical or electrical adjustments have been
made.
Connect the front section of the T5/T7 to the attachment
bracket using the supplied bolt and washer with a 13mm
metric socket as shown. Be careful not to over-tighten the
bolt.
2
3
1
Unlock the strain relief bushing located on the bottom of the
T5/T7 near the pivot bracket mounting bolt by rotating the
nut counter-clockwise and insert the 7-conductor power
cable through the bushing to the top of the T5/T7 as shown.
Ensure there is sufficient conductor on the topside of the T5/
T7 to make connections, and then tighten the nut clockwise
to secure the cable in the strain relief bushing.
Attach the gate attachment bracket to the gate based on the
position and dimension. The T5/T7 gate operator must be
fastened to the gate in a completely level position. Ensure that
the gate attachment bracket is located at a “hard point” on
the gate suitable for opening or closing the gate.
8.5 - GATE BRACKET MOUNTING
F
F
T5 : 1-3/4"
T7 : 2”
8.6 - ACTUATOR MOUNTING
1
2
2
1
2
1
NT
-T51K & NT
-T71K INST
ALLA
TION