Nibe SMO 10, Инструкция по установке и обслуживанию, Страница: 7 / 60

Front panel 5
SMO 10
Hot water symbol.
Indicates when the Extra hot water function
is active.
A is shown when the 24 hour temperature
increase is active
B indicates that a time determined temper-
ature increase, for example periodic, is
activated
Circulation pump symbol.
Shown when the circulation pump is oper-
ational.
Heating system symbols
Shown when house heating is in progress.
Defrosting symbol
Indicates when defrosting of FIGHTER
2010 / 2005 is in progress.
Second row: Value of the current parameter.
Third row: Description of current display para-
meter. Hot water temp is normally
shown.
Fourth row: Shows the current menu number,
key lock and clock
Left keypad
Display
Right keypad
Offset heating curve
D
C
E
Operating mode
This button is used to set the required
operating mode with regard to permit-
ting/blocking the circulation pump and
supplementary energy. The change
does not need to be confirmed with the
Enter button.
The different operating modes are:
Auto mode: SMO 10 automatically selects the oper-
ating mode by taking the outdoor temperature into
account. The circulation pump and additional heat are
permitted to run as needed.
Summer mode: Only production of hot water using
FIGHTER 2010 / 2005. The circulation pump and
additional heat are blocked. However, when Extra hot
water is activated the immersion heater is connected.
Spring/Autumn mode: Only production of heating
and hot water using FIGHTER 2010 / 2005. The circu-
lation pump is operational. The additional heat is
blocked. However, when Extra hot water is activated
the immersion heater is connected.
The current operating mode is shown on the display
when the button is pressed and the mode changes
when you continue to press the button. The display
returns to the normal display mode once the enter but-
ton is pressed.
In the event of an alarm from
FIGHTER 2010 / 2005 the different modes are not
shown.
Extra hot water*
The Extra hot water function is activated
using this button. The change does not
need to be confirmed with the Enter but-
ton.
A: Means that the hot water temperature is increased
to 60 °C (adjustable) during 24 hours. The tempera-
ture then returns to the normal value.
When
A comes on the function is activated.
When A goes out the function is deactivated.
Plus button
This button is used to scroll through the
menu system (forwards) or increase the
value of the selected parameter.
See the section Control — General.
Minus button
This button is used to scroll through the
menu system (backwards) or lower the
value of the selected parameter.
See the section Control — General.
Enter button
This button is used to select a lower
menu in the menu system, to activate a
parameter change as well as confirm a
parameter change.
See the section Control — General”.
This knob is used to change the
heating curve's parallel offset and in
doing so the room temperature.
Turning clockwise increases the
room temperature. When the knob is
turned menu 2.0 is shown on the dis-
play and the value for the calculated
flow temperature changes.
No function.
A B
B
The key lock can be activated in the main
menus by pressing the Plus and the
Minus buttons simultaneously. The key
symbol will then be shown on the display.
The same procedure is used to deacti-
vate the key lock.
* Works with the immersion heater in hot water
heater.