NIBCO, Inc.
13
1516 Middlebury Street • Elkhart, IN 46516 USA • 888-446-4226
PC-100 Battery-powered Pressing Tool
Troubleshooting
Before You Begin
1. Make sure that the battery is charged. Recheck
the battery after several minutes to make sure the
battery is holding its charge.
2. Use a
nonflammable
contact cleaner or pencil
eraser to clean the electrical contacts on the battery
and tool.
3. Reinstall the battery and check the tool again.
Problem
Probable Cause
Probable Remedy
Tool is inoperative.
Dirt, contaminants, etc., in ram area
Clean tool.
of tool.
Pressing tool battery contacts damaged. Reform contacts.
Tool components worn or damaged.
Return tool to an authorized
NIBCO service center.
Jaw does not close completely.
Air in the hydraulic system.
Pull trigger and hold retract button
simultaneously. Hold for approximately
10 seconds.
Return tool to an authorized NIBCO
service center.
Battery load display flashes
Battery charge low.
Charge or replace battery.
constantly.
Tool loses oil.
Damaged internal seal.
Return tool to an authorized NIBCO
service center.
Oil plug not installed properly.
Return tool to an authorized NIBCO
service center.
