NIBCO, Inc.
10
1516 Middlebury Street • Elkhart, IN 46516 USA • 888-446-4226
PC-100 Battery-powered Pressing Tool
Operation
(cont’d)
For 2-1/2" through 4" copper tubing sizes:
1. Select the proper size pressing chain for the
intended application. Examine the chain for wear,
damage, dirt or copper buildup. Replace if worn or
damaged and remove any dirt or copper buildup
with a brush or soft cloth with light lubricating oil.
2. Disengage the release pin on the pressing chain
(see view below) and open the chain. Install the
pressing chain around the fitting to be pressed and
re-engage the pin on the pressing chain.
3. Check that the red protective sleeve is in the rear
position and the
chains 2-1/2" to 4"
marking is
visible on the PC-100 tool. If not, depress the button
on the protective sleeve and move the sleeve to the
rear position (see view below). Release the button to
secure the protective sleeve.
Release pin
(pull to release)
Swing to open
chain unit
4. Depress retract button (part #2, page 5) to retract
rollers to the back position or complete a trigger
cycle to achieve same result.
5. Depress lock pin 3 (see views below) and rotate
counterclockwise to disengage the lock pin on the
pressing tool.
Before installing the pressing jaws,
remove battery to avoid unintentional
operation.
Failure to observe this warning could
result in severe injury or property
damage.
3
2
1
Part #2
(retract button)
