©
National Instruments Corporation
7
NI-FBUS Installation Guide for Windows 2000/XP
4.
As shown in Figure 6, insert the AT-FBUS board into any unused
16-bit ISA slot with the Fieldbus connector sticking out of the opening
on the back panel. Make sure all pins are equally far into the connector.
Although it might be a tight fit, do not force the board into place.
Figure 6.
Installing the AT-FBUS Board
5.
Screw the mounting bracket of the AT-FBUS board to the back panel
rail of the computer.
6.
Keep the top cover or access port off until you have verified that your
resources are non-conflicting. This is described in the
Set the NI-FBUS
Software to Use Your NI-FBUS Board
section of Chapter 2,
Installation and Configuration
, of the
Getting Started with Your
AT-FBUS and the NI-FBUS Software
manual.
7.
Power on your computer.
8.
From the
Start
menu, invoke the
Device Manager
. Select
Settings»
Control Panel»System»Hardware»Device Manager
. Select the
menu item
Show hidden devices
as shown in Figure 7.
