Front Panel
Power indicator - This LED is GREEN when the Power2
is on and AMBER when it is in standby mode.
Standby switch - This switch gives front panel access to
the standby function. It switches between standby and
on.
Channel Status Indicators - These LEDs indicate the
status of each of the two channels.
GREEN - the channel is on and working properly.
RED - the channel is in fault condition.
Off - the channel is in standby mode.
Operation
By now you should have the audio, speaker, control and
power connections done. Now you can turn the power
switch located on the rear panel to the ON position.
After a brief period, the standby LED should light up and
indicate that the unit is in standby mode. Touch the
standby button on the front panel to switch the Power2
out of standby mode. The LED will change to Green and
the Power2 is now up and working.
The power switch on the rear panel should be left on all
the time, since when in standby mode the Power2 draws
very little current. Only if you will not be operating the
Power2 for an extended period of time, you may switch
the power off.
Care and Maintanance
You may need to dust or clean the Power2 every once in
a while to maintain its beautiful finish.
WARNING:
Make sure the power cable is
unplugged before cleaning.
Never use solvents, they will damage the surface. Only
use very soft cloth and very mild soapy water (1/2 ounce
of dish soap per gallon of water) on the top, sides and
front. Never clean the rear panel this way, this may dam-
age the connectors. Simply dust the rear panel. Let the
Power2 dry for an hour before returning it to operation.
12
