Nexus RACE BOX, Инструкция по установке и эксплуатации

Страница: 33 / 44

English RaceBox
32
;
; If POSITION_DATA_SOURCE is set to a NMEA 0183 channel, then
use
; this parameter to set the baud rate. Only standard baud rates
are
; supported. This parameter defaults to 4800 baud. See the
; instruction manual for further details.
;
POSITION_NMEA_DATA_RATE = 38400
;
;
;
; The status LEDs can be turned off to conserve
; power. Each LED uses up to 20ma when on solid.
;
; Valid settings are ON or OFF
;
DATA_LED=ON
INFO_LED=ON
ERROR_LED=ON
;
;
; The damping level for TBS and TWA can be set here. Two choices
; for damper setting are available. You can use the exact
; same scale as Nexus uses, which is from 0 to 9. Alternatively,
; you can simply set the number of seconds. If you set the
; number of seconds, then the RP4N will average all the
; past TBS values for the past n seconds, where n is whatever
; value you set, and present this result.
;
; A Y here will cause the RP4N to use the Nexus damping scale.
; Any setting other than Y will use the number of seconds. In
; both cases, the number must be a whole number of 0 or greater.
;
USE_NEXUS_DAMP_SCALE_PBS=N
DAMP_LEVEL_PBS=5
;
USE_NEXUS_DAMP_SCALE_TWA=N
DAMP_LEVEL_TWA=5
;
USE_NEXUS_DAMP_SCALE_TWS=N
DAMP_LEVEL_TWS=5
;
USE_NEXUS_DAMP_SCALE_BSP=N
DAMP_LEVEL_BSP=5
;
;
;
; How frequently should the PBS/TBS display be updated? Enter a
; whole number of seconds 1 or greater. This parameter defaults