Nexus RACE BOX, Инструкция по установке и эксплуатации

Страница: 36 / 44

RaceBox English
35
; Starting the Nexus countdown timer will not start the RP4N
; timer, and therefore even if you start the Nexus timer, unless
you
; also start the RP4N timer (which starts the Nexus timer) you
; will be out of sequence. Therefore, we recommend that you
always
; use the RP4N to start the Nexus countdown timer. This will
make
; sure there is no confusion about whether or not the RP4N is
; "in starting sequence" or "out of starting sequence."
;
; Do not set CAD to TTB, since CAD can not display a negative
; number. Also, CAD only displays numbers between 0 and 359,
; so it is also a poor choice for FTL.
;
; TTL and TTB are displayed as minutes.seconds. Therefore,
; CAD is also a poor choice for TTL, as it will only display
; properly when TTL <= 3:59.
;
; You can also set a value to OPT, which will tell you
; the optimum wind angle for the current true wind
; speed. If the true wind angle is less than 90, the
; optimum up wind angle is presented. Otherwise, the
; optimum down wind angle is presented. Both of these
; values are calculated based upon the optimum values
; found in the polar table. We suggest using this
; with the CAD field.
;
; OFF - Display no data in this field
;
;
; TTL - Time to line (Only works while in starting sequence if
; a line is pinged)
;
; TTB - Time to burn (Only works while in starting sequence if
; a line is pinged)
;
; FTL - Feet to line (Works in or out of starting sequence if a
; line is pinged)
;
; BL - Boat Lengths to line (Works in or out of starting
sequence
; if a line is pinged)
;
; MTL - Meters to line (Works in or out of starting sequence if
a
; line is pinged)
;
; BIAS - line bias (Works in or out of starting sequence if a
line