Nexus NX2500, Инструкция по установке и эксплуатации

Страница: 13 / 52

English VHF NX2500
12
5.1 DUAL WATCH (DW)
Dual Watch enables the Radio to scan between the selected channel and priority
channel (normally CH16). In Dual Watch mode, the DW indicator will appear on the
bottom line of the LCD.
Note that the Radio will not transmit, nor will alternative channels be able to be selected
while in Dual Watch mode. To restore normal operation press
(F) key again or press
channel (16) key.
5.2 Full Scan (FS)
This function scans through each channel sequentially until a signal is detected above
the squelch level set. Once the signal ends or drops below the squelch level, the Radio
will continue scanning. Alternatively, you can instruct the NX2500 to continue scanning
even if a signal has been detected on any particular channel by pressing the
▲ key
once. When in Full Scan mode, FS will appear on the bottom line of LCD.
Note that the Radio will not transmit, nor will alternative channels be able to be selected
while in Full Scan mode. To restore normal operation press
(F) key or press channel
(16) key.
5.3 Memory Scan (MS)
The Memory Scan operates in the same way as the Full Scan, except that it will only
scan channels that have been entered into the Scan Memory. If no channels have been
entered into the memory then this function will not be available.
When in Memory Scan mode, “MS” will appear on the bottom line of the LCD.
5.4 Tag Channel
This function is to tag or cancel tag on a channel, which means select or unselect a
channel for Memory Scan. If a channel is tagged then the “M” indicator will appear on
the bottom of LCD.
To tag a channel, enter the desired channel number on the Microphone controller and
press “F” on the front panel. Select TAG CHANNEL and press “F” again. To delete the
tag for a channel, repeat the procedure above.