Nexus Autopilot R-1600, Инструкция по установке и эксплуатации

Страница: 36 / 54

AUTOPILOT English
8-35
7.5 (25) 6 10
12 (40) 8 8
Make sure, that the wire size between the battery and the point where you will connect
the wire to the Course Processor is big enough to secure power supply to all other
connected electrical units on board. If you are in doubt, ask your local electrician.
9.4 Course Processor
9.4.1 Location of Course Processor
The Course Processor must be mounted on a dry, flat and vertical surface below deck,
at least 500 mm (20") from radio receiving equipment. Since all wiring originates at the
Course Processor, it should be centrally located to minimise lengths of wiring. It is most
important to minimise the runs of power and motor leads since voltage drop in these
cables will reduce steering capacity.
9.4.2 Installing Course Processor
To mount the Course Processor, remove its cover screws. The 4 inner mounting holes
are now exposed. Mount the Course Processor with 4 screws (not supplied).