8
2
I
NSTALLING
THE
OSU
To install the OSU:
1
Attach the mounting bracket to the outside of the house.
2
Set the OSU inside the mounting bracket.
3
Tighten the lower mounting bolt to hold the OSU in place.
The following sections describe these steps in greater detail.
Attach the mounting bracket to the outside of the
house
1
Make sure you install the OSU on the side of the house that has
the greatest exposure to the communications tower of your ser-
vice provider.
When you purchase your OSU, the service provider can provide
you with information about tower locations that can provide the
OSU with greatest signal exposure. This information will help
you understand the best side of the house on which to mount
the OSU.
2
Install the mounting bracket to the house. The bracket (like the
OSU) must be installed vertically.
•
Drill the two top holes 1.25 inches apart. Drill the bottom
hole 7 inches below the top hole.
•
If possible, drill one upper hole and its corresponding lower
hole into a stud.
•
After the holes are drilled into the house, drive the screws
through the holes on the mounting bracket and into the
house.
Содержание Expedience OSU-2510
Страница 4: ...2 Connecting the OSU to a network 24 FCC information 25...
Страница 7: ...3 Figure 1 shows the OSU Figure 1 OSU...
Страница 8: ...4 Figure 2 shows the network interface manager box Figure 2 NIM box...
Страница 32: ...2...
