Vehicle Installation
20
2
Connect the free end of the ignition cable to a fused vehicle circuit
which pr12V DC when the engine is running and no voltage
when the vehicle is off.
3
Connect the other end (with the plug) to the iR1200 jack labeled
IGNITION (refer to Figure 7 – Front Panel Layout).
Modem Data Cable Installation
The iR1200 Rugged Modem can be connected to the host DTE equipment using a
standard “straight through” 9-pin to a 9-pin serial cable.
The following part can be used:
4
5200-C5-RFM – eLutions Power Cable
The following table contains the steps for connecting the data cable:
Connect one side of the 9-pin cable to the iR1200 communication
connector and the other side of the DTE.
GPS (optional) Data Cable Installation
The iR1200 GPS Enabled Modem can be connected to the host DTE equipment using a
standard “straight through” 9-pin to a 9-pin serial cable.
The following part can be used:
1
5200-C5-RFM – eLutions Power Cable
The following table contains the steps for connecting the data cable:
Connect one side of the 9-pin cable to the iR1200 communication
connector and the other side of the DTE.
