
2. Attach the first Nexsan Storage Expansion to the Nexsan Storage System.
Figure 3-17: Connecting Nexsan E32 to Nexsan E32X
PSU
F
AN
PSU
F
AN
EXP 0
EXP 1
STAT
MGMT
SERIAL
SW0
NETWORK PORTS
HOST
L1
L0
EXP 0
EXP 1
STAT
MGMT
SERIAL
SW0
NETWORK PORTS
HOST
L1
L0
PSU
F
AN
PSU
F
AN
0 - EXP • OUT - 1
0 - EXP • IN - 1
L0
L1
L0
L1 STAT
0 - EXP • OUT - 1
0 - EXP • IN - 1
L0
L1
L0
L1 STAT
a. Insert one SAS cable into the
EXP 0
port on the top RAID Controller of the Nexsan Storage
System.
b. Insert the other end of the SAS cable into the
EXP IN 0
port on the top Expansion Controller of the
Nexsan Storage Expansion.
c. Repeat steps a and b, connecting the
EXP 1
port of the top RAID controller to the
EXP IN 1
port
on the top Expansion Controller.
d. Repeat steps a through c to connect the bottom RAID controller to the bottom Expansion
Controller.
CAUTION
: RAID Controller 0 MUST be connected to Expansion Controller 0, and RAID
Controller 1 MUST be connected to Expansion Controller 1.
3. Using the supplied power cords, connect each PSU on each Nexsan E32XNexsan E18X BT60X
Nexsan Storage Expansion to main power.
Note
While the Nexsan Storage System is powering up, the storage system fans spin up to full speed,
then throttle back. This process is audible and is expected behavior.
4. Wait approximately 5 minutes for the firmware in the Nexsan Storage System to properly configure the
connections to the Nexsan Storage Expansion (or Nexsan Storage Expansions).
5. After 5 minutes, verify through the graphical user interface (GUI) that the Nexsan Storage Expansions
and all of their disk drives are recognized by the Nexsan Storage System and that no errors are
reported.
Note
If either of the
EXP IN
LEDs are flashing amber, you must remove the power cords from the
Nexsan Storage Expansions, correct the cabling (see steps 3 and 4), and then reapply power to the
Storage Expansions. If any
EXP IN
LEDs are still flashing amber, contact Technical Support. See
on page v for phone numbers and e-mail addresses.
Chapter 3: Installing the Nexsan Storage System
Nexsan E18X and Nexsan E32X
Installation Guide
Nexsan
39
3