Nexo NXAMP4x1mk2, Руководство пользователя

Страница: 51 / 70

DPU DIGITAL PATCHING UNIT FOR NXAMP
NXAMPMK2 USER MANUAL PAGE 51 / 70
(1) Speaker Name
The speaker name is indicated next to each plug to be used. For example, bellow for a set of PS15R2.
You will notice that the second line of the display is used, meaning that the output is on the 2+/2- pair of
each speakON 4 connector. Note the arrow to each SPK4 connector.
For an Alpha setup, using speakON 8 connector:
The S2 and the B1-15 have an arrow to each side (one to the SPK8, the other one to the SPK4) because
you can either use a SPK4 to connect directly the S2 and the B1-15 or you can use a SPK8 to a M3 cabinet,
from which you will link a S2 or B1-15 using a SPK4.
The M3 cabinet can be connected using SPK8 only so it shows only arrow to this plug. Note that the M3 text
is displayed on both lines because it is an active speaker using both 3+/3- pair and 4+/4- pair of the SPK8
connector.
(2) Speaker Mode
For some setups, the mode is shown also on the display alternatively. For example, for our PS15R2 setup,
if you edit the setup for Channel 2 and select a monitor setup, the DPU display above will alternate with:
This information indicates that the PS15R2 to be connected on the first SPK4 should be a passive (PA)
cabinet, the one connected to the second SPK4 will be passive (PA) also but uses a Monitor setup.
For our Alpha example, the S2 and the B1-15 has no alternate information to display but the M3 output will
show that 3+/3- pins are connected to the MF whereas the 4+/4- are connected to the HF speaker of the
cabinet.
(3) Amplifier channel
The amplifier channel in use on each output is also shown alternatively with the displays above. For example,
in the four PS15R2 channels case:
And in our Alpha setup example: