Nexo GEO M10, Руководство по установке

Страница: 48 / 79

Page 48/79 GEO M10
HARDWARE SETUP PROCEDURE
IMPORTANT
Ensure hoist hook(s) is (are) properly secured to VNT-BUMPM10 or VNT-EXBARM10
shackle(s)
Ensure that all quick release pins are locked
- Insert shackle(s) in bumper or in extension bar in required hole(s) as indicated in NS1 design and
secure shackle bolt(s)
o
If using 1 hoist on VNT-EXBARM10, holes are
“A” to “Q”
o
If using 2 hoists on VNT-EXBARM10, connect these using extreme holes
(“A” and “Q”)
o
VNT-BUMPM10 without extension bar can only be flown with 2 hoists from front and rear
rigging points
- Connect hoist hook(s) to shackle(s) and lift assembly to sufficient height in order to connect a second
GEO M10
- Position second GEO M10 cabinet with AutoRig
TM
in automatic lock position, and lock front points to
first GEO M10
- Unlock GEO M10 link bar
- Pull the latch to engage the guide in GEO M10 rear slot.
- Adjust the angle by inserting quick release pin BL820 in proper hole.
- Connect subsequent GEO M10 cabinets as with second.
IMPORTANT
Ensure that bumper quick release pins are properly locked into GEO M10, and that all
AutoRig
TM
and rear connecting points are locked
- Lift cluster to NS-1 defined rigging height, secure cluster horizontally to prevent it from rotating;
- Secure bumper with secondary safety steel.
IMPORTANT
The requirements for secondary safety systems vary with territories. However, the
secondary safety steel MUST have a SWL equivalent or greater than that of the rigging
system.