NexLink IOP-1, Инструкция по эксплуатации

Страница: 19 / 24

Beta V1.00 07/01/2012 Page | 19
4 ‐ If this jumper is in, the SETTINGS menu in the gateway is enabled. This is mainly used to first
set the passcode of the gateway. It is installed by the factory at the time of purchase. After the
user sets up the passcode, this jumper should be removed. (See the section “SETTINGS MENU”)
2 ‐ If this jumper is in, the passcode prompt will be disabled and full access to the gateway will be
available without entering a passcode. This feature might be convenient if the unit is installed
on an inside PBX analog telephone line where there would be limited personnel use.
1 ‐ If this jumper is out, the timeout timer mentioned in the “Operation” section of this manual is
set to 4 minutes. If the jumper is installed, it will be set to 8 minutes. The factory default is not
installed or 4 minutes.
Reassembly of the Gateway
Place the PC board back on the 2
nd
groove from the bottom of the unit. Slide the pc board until
the LEDs pop through the holes in the front panel. Replace the rear panel, then screw the two
screws back in.