12.Igniter Wire Installation
Insert the side burner ignition wire to the ignite module
as shown in Fig.19
Note: You only need to insert the side burner ignition
wire, the other five wires have been pre-assembled.
Reminder:
While completing igniter wire
installation, make sure there is a 3 mm
gap between the igniter pin and the side
burner, so that it ignites easily.
SB igniter wire
Fig.19
Assembly Instructions
Fig.20
13. Battery Assembly
Unscrew the electronic igniter button and
place the battery (C1) into the housing with
positive terminal (+) facing outward.
14. Grease Tray, Greasy Box Assembly
Z
A1
Fig.21
E
BB
14a) Use two 5/32-in.X10 mm Truss
Head Screws with locking washer (BB)
and two 5/32-in flat washers (HH) to fix
the main grease tray (V) and tank heat
shield (E) as shown in Fig.21
14b) Place the main grease tray (V)
with Tank heat shield (E) and Grease
box (A1) from the rear of grill as shown
in Fig.21
V
C1
2X 2X
HH
18
positive terminal (+) facing outward.
Replace the ignition button after the battery
has been installed as shown in Fig.20
