22
INSTALLATION INSTRUCTIONS
¾
Before Using Your Unit
•
Remove the exterior and interior packing.
•
Before connecting the unit to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
¾
Setting the Temperature Control
•
Your unit has only one control for regulating the temperature in the compartment. The
temperature control is located on the upper side of the compartment.
•
The first time you turn the unit on, set the temperature control to “5”.
•
The range of the temperature control is from position
“
OFF
”
to
“
5
”
. “1” is the warmest and
“5” is the coolest. After 24 to 48 hours, adjust the temperature control to the setting that best
suites your needs. The setting of
“
3
”
should be appropriate for normal use.
•
To turn the appliance off, turn the temperature control to
“
OFF
”
.
¾
Electrical Connection
•
Turning the temperature control to
“
OFF
”
position stops the cooling cycle but does not shut
off the power to the unit.
•
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
¾
Food Storage
•
Use plastic wrap to keep food and place evenly on wire rack or drawer.
•
Allow hot food to cool before put into this refrigerator.
•
Allow space between different foods inside refrigerator.
•
Keep food dry before storage.
¾
Installing Your Unit
•
Remove food from refrigerator if power is lost.
•
Place your unit on a floor that is strong enough to support the unit when it is fully loaded. To
level your refrigerator, adjust the leveling legs at the bottom of unit.
•
Locate the refrigerator away from direct sunlight. Direct sunlight may affect the acrylic coating,
and heat sources may increase electrical consumption. Extremely cold ambient temperature
may also cause the unit not to perform properly.
•
Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not cut or remove the
third (ground) prong from the power cord under any circumstances. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized
products service center.
•
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing food in the refrigerator.
Refrigerator Specifications
Voltage (V)
110
Frequency (Hz)
60
Current (A)
1.45
Input Wattage (W)
80
Volume (cu.ft.)
1.7
Dimension (mm)
440*462*493
Refrigerant R134a
High Pressure (psig)
186
Low Pressure (psig)
88
Net Weight (kg)
17
