Basic Lighting Procedures
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts then
the burner can be match lit.
Lighting rod-Here is your instruction:
Match light extension rod
Use this device to match light your burners
Simply place a lighted match between the coils on the
end of the extension rod and hold next to the burner to
ignite. (see reference Pg)
If you’ve just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away from
the grill as possible. Insert a lit match attached to tight
lighting rod or lighter through the cooking
grids to the burner.(see next page) Press the control
knob and rotate left to the HI setting, continue to press
the knob until the burner ignites. Burner should light
immediately. If the burner does not light in 4 seconds
turn the knob off, wait 5 minutes and try again.
1. Familiarize yourself with the safety guidelines at
the front of this manual. Do not smoke while
lighting grill or checking gas supply connections.
2. Be sure the LP gas tank is filled.
3. Check that the end of each burner tube is
properly located over each valve orifice.
4. Be sure all gas connections are securely
tightened.
WARNING
Failure to open grill lid during the lighting
procedure could result in a fire or explosion
that could cause serious bodily injury, death,
Rear Burner Lighting Instruction
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before
each use.
Step 1. Push and turn the desired knob to
HI/
Ignite
Do not attempt to light the grill if odor of gas is
present. Call for service 1-866-984-7455
Step 2. Press the electric igniter 3 to 4 seconds
to light the rotisserie burner
CAUTION: Spiders and small insects
occasionally spin webs or make nests in the grill
burner tubes during transit and warehousing.
These webs can lead to gas flow obstruction
which could result in a fire in and around burner
tubes. This type of fire is known as
“FLASH-BACK” and can cause serious damage
to your grill and create an unsafe operating
condition for the user.
Step 3. After the rotisserie burner is lit, adjust the
knob as desired
Visually check the burner flames prior to each
use,The flames should look like this picture,if they do
not ,refer to the burner main tenance part of this
16
