Nexa NE-1 NAVY CUB, Инструкция по эксплуатации

Страница: 5 / 20

Trial fit the vertical stabilizer in place . Check the alignment
of the vertical stabilizer. When you are satisfied with the
alignment, use a pencil to trace around the right and left
of the stabilizer where it meets the fuselage.
Cut away only the covering
on the left and right side.
Remove the vertical stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering inside the lines which were marked above.
Realign the vertical stabilizer , ensure that the vertical stabilizer is perpendicular
to the horizontal stabilizer. Then glue the vertical stabilizer into the fuselage, using
a generous amount of 5 min. Epoxy. Apply thin epoxy to each of the two joints and
the entire bottom edge of the vertical stabilizer, use a generous amount to ensure
to strong bond.
10
11
A B
5 min.
Epoxy
12
2mm
3x12mm screw
TAIL WHEEL & RUDDER
NAVY CUB section 4
2mm
1mm
2x12mm screw set
Control horn
...........2
2x30mm screw
...6
VERTICAL STABILIZER NAVY CUB section 3
90 90
FUSELAGE - REAR VIEW