Copyright Velocomp LLP 2005-2015
42
5) Wind sensor has obstructed access to wind (hands, aero bars). See instructions
to correct.
6) ADVANCED USERS ONLY: Coast Downs were done improperly. Use ISAAC to
perform “Device/Set Up Newton...” procedure (pages 10-12).
Problem: Power readings seem to be “off” for first five minutes only, then
become “normal”
Possible causes:
1)
Mount has been rotated. Keep riding for 8 minutes, after which watts will
become normal. Then do a trip reset to memorize the fix. Make sure mount
does not rotate.
2)
Tilt setting has been disturbed. Keep riding for a few minutes, and power
numbers will self correct. Do a Trip Reset to preserve corrected tilt setting.
Problem: I get intermittent watts readings or zero watts readings.
Possible causes:
1)
Your cadence sensor has been bumped away from the cadence magnet. Make
sure the cadence magnet passes within two coin thicknesses of the cadence
sensor. When cadence is zero, watts are zero.
2)
CAL RIDE was done improperly. Perform a Cal Ride, pages 11-12.
Problem: Unit locks-up (screen displays numbers but buttons don’t work)
Perform a “Hard Reset” as described on pages 19-20.
Problem: I can’t download data to my computer and/or upload data to my
Newton
Possible causes:
1)
Newton is sleeping (nothing is visible on the display screen). Click the center
button to turn on the Newton and make its display visible.
2) USB cable isn’t plugged into your computer.
3) USB cable isn’t plugged in to your Newton
4) ISAAC software and/or USB drivers are installed improperly. Contact Technical
Support for assistance,
Problem: My screen says “Fit Test” or “User” or “Fat” or “Cardo” or “strn” or “tt”
or “tE” and I can’t get back to the main screens.
Cause: You entered the fitness training screens by press-holding the right arrow.
1)
To get out of the fitness training screens, press-hold the right arrow. “End
Train” will flash and you will be returned to the main screen.
Problem: On my Newton, one or more of “Indoor Trainer” or “PowerStroke” or
“Newton Tracker” or “CdA” features don’t work.
Cause: Your unit does not have one or more of the above optional features enabled.
1)
Go to
http://store.ibikesports.com/performance-feature-
upgrades/?sort=priceasc
to purchase optional feature upgrades
Problem: I have multiple bikes and have created new profiles for them, but when
I move my Newton to a different bike, it sometimes doesn’t change profiles
correctly.
Cause: More than one set of your ANT+ sensors are active at the same time, and your
Newton is pairing to an incorrect sensor set.
1)
Move the bike you want to use at least 50 feet away from your other bikes.
Then, do a “Trip Reset”. Your Newton will find the correct set of sensors.