Newman Windermere 5 SE, Инструкция по установке и эксплуатации

Страница: 35 / 57

35
fuel, etc. This means that it may take some time before you get to know the correct
functioning of the stove under any given circumstances.

Note: (To load fuel, the door should be opened slowly , avoiding a sudden
rush of intake air, so that smoke does not escape into the room). Always close the door after re
fueling.

Dampers left open. Operation with the air control or appliance dampers open can cause excess
smoke. The appliance must not be operated with air controls, appliance dampers or door left
open except as directed in the instructions.
Operation with the door left open.
Warning: The firebox door shall be kept closed except during ignition, refueling and
removal of residue material.
It is recommended providing the ash pan is not full of residue material that the ash pan is
emptied when the fire is not in use and the stove, and all residue and components are cold.
The stove door should never be opened when the stove is being fired vigorously and only
opened when the fire requires lighting, when the fuel is low and needs to be re fuelled or
removal of residue material via the ash pan, at all other times the stove door
MUST BE
CLOSED.
Operation with the door open can be dangerous and cause excessive smoke. The appliance
must not be operated with the appliance door left open except as directed in the instructions.
Stove shut down for both wood and approved smokeless fuels.
If there is still fuel burning in the stove firebox, it is not recommended closing the air controls
completely unless there is a chimney fire in progress (See section 4.0
User manual, under the
heading (A plan to deal with a chimney fire as follows). Closing the air controls during the
combustion process will cause poor combustion and could cause a buildup of gases that could
ignite dangerously .
Always ensure that the air controls are open enough to maintain some flames in the firebox.
If it is required to shut down the appliance, then run the stove on a higher setting without over
firing until all the fuel has been burnt before closing the air controls.
Odours when using the stove for the first time
Painted products:
The stove may emit an irritating gas when used for the first time, and it may smell a little. The
room should be thoroughly ventilated. Let the fire burn with a high draught (without over firing)
until all traces of the gas have disappeared and no smoke or smells can be detected.
Evacuate all
people from the room until all odours have cleared. If for any reason the odours do not clear, do
not add more fuel and allow the fire to extinguish, seek professional assistance.
Air Controls:
See figure 4
Always use the long ash pan / operating tool and stove mitten to operate the air controls
For wood burning the amount of heat emitted by the stove is regulated by using the secondary air
control.