Newman Windermere 5 SE, Инструкция по установке и эксплуатации

Страница: 43 / 57

43

Check the register plate (for installations that require) is in good serviceable condition and
fitted correctly.

Check the Carbon Monoxide alarm to ensure it is installed and operating correctly.

Check that any combustible materials are a safe distance from the stove.

Check room ventilation air supply to ensure the safe operation of the stove. Air Supply: It is
essential to check any air supply ventilator in the room is suitable and fully clear and open.

Check for correct operation of all air controls.

Check the correct operation and adjustment of the door handle.

Clean the glass panel as section 4.5.2

Clean or repaint the external black painted surfaces of the stove as section 4.5.4

All parts to be re installed to the stove into their correct positions.

To carry out correct and safe operation tests of the stove as listed in section 3.8 Commissioning
and handover.

Refresh the user on the safe operation of this stove.
4.4.1 Replacing the glass panel and rope seal.
Only change the glass panel and rope seals when the stove is not in use and completely cold.
Wear suitable protective gloves, mask and goggles during this process.
Replacing glass panel to stove door.
See figure 6
In the unfortunate event the glass panel to main door gets damaged the glass panel must be
replaced with an approved stove glass panel, by an
approved and competent stove installer
such as Hetas registered (England & Wales) or equivalent for other Nations.

Open the door. Remove the glass panel by removing the 4 screws and fixing tabs located to the
inside of the door, the glass panel will require supporting during this process. Remove the
glass panel. Check the glass rope seal for wear and damage, if found replace the rope seal.
When fitting the new glass panel locate the glass so it is central to the stove glass seal and
located correctly to ensure the glass panel will be sealed to all sides. Replace the 4 screws and
fixing clips and secure the glass panel to door.
Do not over tighten the screws as this can
damage the glass.
Replacing the glass rope seal

Remove the stove door by removing the 4 screws retaining the hinges to the door and place
face down onto a soft sound surface so as not to damage the door or glass. To replace the glass
panel to door seal: Remove the glass panel. Remove the old door rope seal and scrape old glue
from the door locating groove.

Clean the locating groove with a clean, dry cloth to remove all old dust and debris. Use
suitable stove rope glue into the rope locating groove and press the new rope into the locating
groove, noting the joint positions. Replace the glass panel. Refer to the stove rope glue
manufacturer’s instructions for drying times and when the stove can be used after the stove
rope glue has been used.

Using the appliance with a damaged glass seal or damaged glass can cause dangerous fumes to
enter the room, or the appliance to over fire resulting in damage