Newman Easedale 5 SE, Инструкция по установке и эксплуатации

Страница: 31 / 53

31
approved and qualified chimney sweep to ensure that there is no blockage. For example, a
bird may have nested at the top of the chimney.
 If you fire the stove using wet wood or approved smokeless fuel, a lot of the fuel’s thermal
energy will be spent forcing the water out of the wood or approved smokeless fuel, without
releasing any heat to the stove. This incomplete
combustion results in a layer of soot being
left in the stove, pipe, and chimney. this can cause damage to the chimney flue and stove.
Extreme conditions, such as poor draught in the chimney, large quantities of wood or wet
wood, may, in the worst-case scenario, cause an explosive ignition.
Odours when using the stove for the first time
Painted products:
The stove may emit an irritating gas when used for the first time, and it may smell a little. The
room should be thoroughly ventilated. Let the fire burn with a high draught (without over firing)
until all traces of the gas have disappeared and no smoke or smells can be detected. Evacuate all
people from the room until all odours have cleared. If for any reason the odours do not clear, do
not add more fuel and allow the fire to extinguish, seek professional assistance.
Air Control: See figure 4

Always use the long ash pan key and stove mitten to operate the air controls
For wood burning the amount of heat emitted by the stove is regulated by using the secondary air
control. The secondary air (air wash system), which is supplied to the combustion chamber over
the internal glass, is controlled using the upper air control lever, move to the left to open and to the
right to close.
For approved smokeless fuel burning the amount of heat emitted by the stove is regulated by using
the primary air control which is a lever located to the front door below the glass, move to the left
to decrease the burn rate and move to the right to increase the burn rate.
A third air inlet (normally named tertiary air) provides a constant, pre-heated air supply to the
combustion just above the fire, the tertiary air control to be pushed inwards to the closed position
when burning wood or approved smokeless fuels.
The exact positioning of the air controls to achieve optimum burn for the Easedale 5 SE will
depend on many factors such as weather conditions, chimney size and local topography. However,
to give some guidance please read section 3.2.1 and section 3.2.2.
3.2.1 Use with wood: See figure 4

It is recommended always to use approved and suitable stove tongs for loading and
refueling the stove with wood to avoid any part of your arms and hands entering or
touching the stove. Use the stove mitten to hold the tongs.

Always use the long ash pan key and stove mitten to operate the air controls.
Lighting
Important:
Ensure the area around the stove is clear of all obstacles so as not to be a trip hazard and
allowing a totally un obstructed space whilst lighting, re fueling, adjusting the air controls,