National Electronics & Watch Co,. Ltd.
BC04
Power Saving Screen:
This watch has a power saving feature to prolong battery life. When GPS is OFF, HRM is not
linked, and no key operation for 1 minute, the display will auto go to Power saving screen. In
power saving Screen, Press S7 to go to Run mode. Press any other key will go from power
saving screen to Time mode.
Note: If GPS is ON or Chronograph is running, it will not go to power saving screen.
The watch will display only the date, battery level indicator and time in power saving screen.
Step 2) Charging the Battery:
Charge the unit for at least 4 hours before first use. The length of time for a fully charged battery
will last depend on the actual usage. It is recommended to regularly re-charge your battery
every 1-2 months even if it is not used to maintain good battery condition.
2.1)
Plug your USB PC link cable to your PC
2.2)
Align the charging clip with the contacts on the back of the watch.
2.3)
Connect the charging clip securely to the watch.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure proper
electrical contact and to prevent corrosion.
When the battery is low, it is time to charge the GPS watch.
Note:
You cannot turn ON the GPS when the battery is low.
When it displays check the charger, re-adjust the clip and make sure there are no contamination
or dirt between the contacts of the clip and the back of the watch.
Once the battery is full, it will display CHARGING COMPLETE.
Step 3) Configure your watch:
Before using your GPS watch, you have to do the following:
3.1)
Set the Alarm, Time 1, Time 2, and display format. Go to
Time sub modes
for the details
on how to set these parameters. Time and Alarm can also be set in
SET
mode.
3.2)
Go to
SET
mode to set
TIME
,
ALARM
,
UNITS
,
USER
details,
DISPLAY
format
, AUTOLAP
,
BAROMETER
,
ALTIMETER
,
HRM
,
HRM LINK
,
HRM ON/ OFF
, LCD
CONTRAST
,
KEYTONE,
and
NIGHT
mode
.
Step 4) Acquire Satellite signals:
In order to get the correct time of day and begin using your GPS watch, you have to acquire
GPS signals. It may take a few minutes to get the signals.
4.1)
Go outside to an open area away from tall buildings and trees. Orient the GPS antenna
towards the sky for best reception. The antenna is located at the 6 o’clock position of the
watch.
Note: In order to accurately navigate the GPS, you need to have a good line of sight to the
satellites.
4.2)
Stand still and do not begin moving while searching the Satellites until the signals are
already received.
4.3) How to Turn ON the GPS:
Press S9 to turn ON the GPS. The watch will start locating the
satellites. After receiving the satellite signals, it will automatically go to RUN mode ready for
the exercises. The watch will display the relative signal strength on the upper sight side of
the display:
