Newco 872DS, Руководство пользователя

Страница: 6 / 11

Part No. 803172 Issued 3-29-13 Rev 012015 6
TROUBLING SHOOTING
PROBLEM
CAUSE CORRECTIVE ACTION
Difficulty priming dispenser. 1. Product adjustment screw
turned in too far.
2.
Line blocked/kinked.
1. Turn adjustment dial ¼ turn
C’clockwise(weaker/
stronger) adjustment.
2. Check for kinks. Flush/
Replace lines.
Pulled faucet handle, no
product, no water. 1. Water supply not on. 1. Turn water supply on.
Drink too foamy or bubbly 1. Concentrate BIB empty.
2. Hole or tear in product
tubing prior to BIB
connection.
3. Loose syrup line connection.
1. Load new BIB
2. Replace tubing
3. Check syrup line
connections from check
valve.
Drink inconsistent 1. Handle not pulled fully
during dispense.
2. Low water pressure.
1. Pull handle fully when
dispensing.
2. Ensure minimum of 18 PSI
available.
Water only—no product 1. Concentrate BIB empty.
2. Product hose clogged.
3. Product hose kinked.
4. Check valve not seating.
5. Adjustment screw in too far. 1. Load new BIB.
2. Clean product hose or
replace.
3. Check for kinks.
4. Disassemble and clean check
valve.
5. Turn adjustment screw out
using adjustment dial.
Faucet dripping
1. Some dripping is natural
after dispense. Sustained
dripping may indicate faucet
seal issue. 1. If drips continue remove
nozzle to drain retained
liquid. Replace and observe.
2. Repair/Replace faucet.
Drink too weak 1. Adjustment screw in too far.
2. Check valve not seating. 1. Turn adjustment screw out
Weaker/Stronger adjustment.
2. Disassemble and clean
barbed elbow check valve.
Air bubbles in syrup 1. Loose tubing connection at
QCD or at check valve barb.
2. Worn O-ring on QCD
plunger.
3. Air in bag.
1. Ensure tubing is slid all the
way on to the QCD and
check valve barb.
2. Replace QCD.
3. Stand BIB upright, open
faucet handle and prime
syrup line until all air
bubbles are gone.