Newa NEWA Hobby NH 20, Инструкции и гарантия

Страница: 15 / 44

• When the lights buttons are pressed, they should switch on.
3. Wait for the water temperature to reach the value set in the heater. Must be adjusted to the
desired aquarium temperature using the special knob. It is advisable to periodically check the water
temperature, to ensure that a constant temperature is maintained.
4. Proceed with adding any fish according to your own experience and complying with the
“good practice” regulations for aquariums.
VI. OPERATING AND CLEANING
EVERY WEEK:
a. Clean the inside of the aquarium glass panels with a magnetic brush (not included) to remove the patina of algae (Fig. 11).
b. Clean the LED lighting system protection with a sponge or a wet cloth (Fig. 12).
c. Check the water level. If it is too low, top it up to the required level with water at about the
same temperature as the water in
EN
the aquarium.
d. Check the water temperature using the immersion thermometer provided.
EVERY MONTH:
a. Replace the Newa Cobra filter cartridge choosing among the NEWAQUA media filter cartridges range.
EVERY 3 MONTHS:
a. Rinse the foam cartridge using the aquarium water, so that the bacterial colonies are preserved.
b. Clean the bottom of the aquarium by gently sucking up any deposited sediment. It is advisable to use
the NEWA Pgr gravel cleaning set. This operation should be done with great care in order not to uproot
any plants or leave any roots uncovered. c. Remove any deposits from the rotor and the pump impeller.
VII. TROUBLESHOOTING
If installation has been carried out correctly and the electrical accessories are operating normally, it is
unlikely that any technical problems will arise. If they should, consult an installer specialised in electrical
appliances or contact the aquarium product dealer to make a careful check or to replace the aquarium.
FAULTS CAUSES SOLUTIONS
Apply specific pads on a movable part or along
The cover does not remain
The cover does not remain properly closed. the perimeter of the support, making it finally
completely horizontal (Fig. 14).
properly closed.
The perimeter of the support is not
Contact your local dealer
horizontal.
The lighting system is not connected to the
Connect the plug to the electrical socket
electrical socket
The lighting system are not
A temporary black out ---
in operation
The lighting system is not operating
Contact your local dealer
correctly
The heater is not connected to the
Connect the plug to the electrical socket
The water temperature
electrical socket
does not reach the set The pump is clogged due to dirt or wear
Carry out maintenance on the pump.
levels and tear on the rotor
The heater is not operating correctly Contact your local dealer
15