Whilst every care is taken to eliminate
burrs and raw edges from this appli-
ance, please take care when handling
- we recommend the use of protective
gloves during installation
Moving the cooker
Please note that the weight of this
appliance is approximately
45kg
(500mm wide models), or
50kg
(550mm wide models) (unpacked).
Take care if the appliance needs to be
lifted during installation - always use
an appropriate method of lifting.
Do not attempt to move the cooker by
pulling on the doors or handles. Open
the door and grasp the frame of the
cooker, taking care that the door does
not shut on your fingers.
Take care to avoid damage to soft or
uneven floor coverings when moving
the appliance. Some cushioned vinyl
floor coverings may not be designed
to withstand sliding appliances without
marking or damage.
Clearances & dimensions
Clearances
No shelf or overhang or cooker hood
should be closer than a minimum of
460 mm, but check with cooker hood
manufacturer’s recommendations.
The cooker must have a side clearance
above hob level of 90mm.
This cooker may be fitted flush to
base units. However, for models with
side opening doors, we recommend a
side clearance of 60mm between the
cooker and any side wall to allow the
door to be opened fully.
Cooker dimensions
All sizes are nominal, and some
variation is to be expected. The
‘depth’ of the cooker, as given below,
is to the front of the door and
excluding knobs and handles.
Width is either 500mm or 550mm,
depending on model.
16
1450 mm
580 m
m
500 mm
/ 550 mm
900 mm
INSTALLATION INSTRUCTIONS
25245 00 - NW gas HL 27/09/2002 09:30 Page 18
