17
INSTALLATION INSTRUCTIONS
Assemble grill
Fitting the grill canopy
Fixing screws and washers that are not
loosely assembled in position are in
the plastic bag in the oven pack.
1. There are 4 screws in the back of
the cooker which will secure the
splashplate (through the uprights)
onto the back of the cooker.
2. Loosen the 2 lower screws (2 either
side) in the back of the cooker,
until some of the thread is showing.
3. Remove the 2 higher screws and
keep to hand.
Pick up the splashplate and grill
canopy and lower it onto the back
of the cooker so the slots in the
uprights locate over the loosened
screws.
4. Replace the 4 screws into the
slotted holes and tighten each
screw in turn.
5. Connect the grill pipe from the
tap rail to the straight hexagon
connector.
Make sure the connections
are gas sound.
Grill electrode lead
Feed the grill electrode lead through
the hole at the top left-hand corner of
the splashplate (viewed from rear) and
connect it to the grill electrode.
Do not
feed the wire through the grill shelf
wire slots. Feed any slack lead to the
back of the cooker and clip with the
plastic twist clip provided.
Fit the grill shelf
550mm wide models
Note:
For ease of assembly, slacken the 4
screws holding the canopy to the splash-
plate, before offering up the grill shelf.
1. Remove the four grill securing screws
M4 x 10mm which are loosely assembled
in position on the grill canopy.
2. Offer the grill shelf up to the underside
of the grill canopy with the rubber end
caps right up against the splashplate
and use the four M4 x 10mm screws
to secure into place.
500mm wide models
1. Insert the grill shelf wires through slots
in the splashplate and holes in the
support channels.
2. Locate notch in the hole in the rear
face of the support channel.
3. Fit retaining clips to notches on shelf
wires - the clips may be removed when
cleaning.
Fit the grill pan
Place the grill pan onto the grill pan
runners and push to the back stop position,
raise the front edge of the grill pan to
engage it onto the grill pan runners. The
grill pan can now be pulled forwards to fit
the front stop position.
Fit the spacers
(550mm models only)
From the rear of the grill canopy, fit
the plastic spacers into the elongated
hexagonal holes as shown.
25245 00 - NW gas HL 27/09/2002 09:30 Page 19
