New Wave Research LCS 4/EzLaze, Руководство оператора

Страница: 17 / 43

Installation
13
To accommodate the laser while maintaining strict safety, the adapter
ring on the microscope trinocular head must be removed and replaced
with the one provided. The new laser adapter ring has a pin which
activates an interlock switch. If the pin is not present, the laser will not
fire.
Note: Install the eyepiece filter before installing the laser adapter ring.
•
Remove the old adapter ring and the three cap screws (2.5mm hex)
which secure it to the microscope. See Fig. 2-1.
•
Install the new laser adapter ring with the interlocking pin positioned
to the right of front/center of the microscope (see Fig. 2-1). Use the
three original cap screws to secure it to the microscope.
A UV tube lens kit allows UV (355nm) energy to be transmitted through
the Mitutoyo FS60 and the FS60Y. IR (1064nm) energy can not be
transmitted through the FS60. The FS60Y does transmits IR energy (no
conversion required).
The A-Zoom microscope requires the Laser adapter kit to mount the
LCS 4. Green (532nm) light passes through all the microscopes without
conversion. The conversion requirements are summarized below:
Table 1: Conversion Kits
Microscope Transmit IR Transmit Green Transmit UV
FS50 N/A No kit needed N/A
FS60 N/A No kit needed UV tube lens kit
FS60Y No kit needed No kit needed UV tube lens kit
A-Zoom Laser adapter kit Laser adapter kit Laser adapter Kit
•
Remove the binocular head by loosening the set screw on the left
side of the microscope (2.5mm hex). The screw is located in the
seam separating the binocular head from the main body of the
microscope (see Fig. 2-1). After the screw has been loosened, the
binocular head can be lifted from the microscope body.
•
Remove the plastic zoom control knob and c-clip from the zoom
shaft. Newer Mitutoyo microscopes require that the cap be removed
Laser Adapter
Ring
Microscope
UV Conversion
Kit
FS60 UV tube lens
kit installation