SMC 4006 / 4006 C
01D19
R
e
pa
ir
&
Ma
int
e
na
nc
e
in
s
tr
u
c
ti
on
s
Res
cue
e
qui
pm
e
nt
Maintenance recommendations after use (every time)
Wear full protective gear during maintenance !
Always act according to the safety instructions as supplied with each tool !
Contact the Holmatro dealer if one of the items does not work properly !
•
Necessary equipment: see check list page 12.
Left: SMC 4006
Right: SMC 4006 C
Step 1
•
Check the cutter for completeness, oil leaks
and damage. Do not use the cutter if it leaks
or is damaged, and contact the Holmatro
dealer.
•
Check general condition of the cutter.
Clean/dry the tool with soft cloth.
•
Check the attachment of the carrying handle.
If necessary, fasten it firmly by tightening the
wing screw.
Step 2
•
Check coupler(s) and dust cap(s) for damage,
dirt and/or oil leakage.
•
Clean coupler(s) with a clean and soft cloth, if
necessary with water and soap.
•
If necessary grease with hydraulic oil or use
WD-40.
•
Check functioning coupler(s) (see page 13).
•
Reconnect loose dust cap(s) to coupler(s).
Step 3
•
Check the functioning of the control handle, it
must automatically return to it’s neutral
position.
•
Contact the Holmatro dealer if the handle
does not work properly.
Step 4
(only for pigtail connection)
•
Check the back of the control handle for oil,
this will indicate that the safety valve has been
activated during use (return line of the tool
was not connected properly to the returnline of
the pump).
•
Clean the deadman’s handle internally by
blowing compressed air in the back of the
handle.
•
Check the hose for damage.
© Holmatro
09/08
While the greatest care has been devoted to the content, it is
possible that the information in this printed matter is incorrect
or incomplete. Holmatro N.V. and its affiliated companies
(hereafter: Holmatro) cannot be held liable in any way for the
consequences of activities undertaken on the basis of this
printed matter. If you have any doubts about the correctness
or completeness of the information, you shall contact
Holmatro (phone number: +31 (0)162-589200).
Nothing from this printed matter can be copied and/or made
public in any way without the explicit authorisation of
Holmatro.
Manufacturing sales & service
Manufacturing sales & service
worldwide
U.S.A., Canada and Latin America
Holmatro Rescue Equipment B.V.
Holmatro, Inc.
P.O. Box 33, 4940 AA Raamsdonksveer
505 McCormick Drive, Glen Burnie, MD
The Netherlands
21061 U.S.A
T
+ 31 (0)162 - 58 92 00
T
+ 1 - 410 - 768 - 9662
F
+ 31 (0)162 - 52 24 82
F
+ 1 - 410 - 768 - 4878
E
E
www.holmatro.com
www.holmatro-usa.com
Pigtail
connection
only !
1 -
3
