SMC 4006 / 4006 C
01D19
R
e
pa
ir
&
Ma
int
e
na
nc
e
in
s
tr
u
c
ti
on
s
Res
cue
e
qui
pm
e
nt
Maintenance recommendations after use, continued
Step 5
•
Check the presence of the lock-nut.
•
Check if the upper moving part can move
freely. If not see page 8 step 9 to adjust.
Step 6
•
Clean the blades after use.
•
Check the blades for damage, remove
upsettings on the blades. Use a file and
abrasive paper.
•
Blades can be turned one time 120°.
•
Replace, or turn blades 120° when blades are
damaged.
•
See page 7 “replacing the blades” to replace
the blades.
•
Lubricate the blades after use with
preservative oil WD-40.
Step 7
•
Check the presence of both locking screws.
•
Both lock bolts should be tightened firmly.
Step 8
•
The best cutting results are obtained if the
blades (jaw opening) are open 0.5 mm to 1
mm at the end of the cutting movement.
•
See page 9 “Adjusting the plunger stroke” to
adjust the plunger stroke.
Step 9
•
Spray Teflon lubricating oil on and between
the moving parts of the centre bolt B while the
tool is opening and closing (cover not shown).
Step 10
•
Clean/dry the tool with soft cloth before
storing it.
•
Lightly oil steel parts with preservative oil
WD-40.
•
Store the cutter in a dry and well-ventilated
area.
•
Do not fully close the cutter, always keep a
few mm for opening, so that the tool can be
stored without pressure.
0.5-1.0mm
2 -
3
