New Wave Research LCS 4/EzLaze, Руководство оператора

Страница: 21 / 43

Installation
17
The power supply has been preset at the factory for the voltage supply
available at your location (100-130, or 200- 240VAC). The power supply
voltage may be adjusted for 100/115 or 230 VAC operation, if
required.use ring set screw.
Center the spot marker on the television monitor by adjusting the video
camera mirror on the lower side of the camera adapter.
•
Adjust the image color by using the set screw (1.5mm hex) on the
ottom of the camera adapter port.
•
Adjust the spot’s image location by releasing the two socketed head
screws and rotating the mounting plate. When the image is properly
positioned, re-tighten the head screws (see Fig. 2-2, Detail A).
The LCS 4 RS232 Computer Interface connector is located on the rear
panel of the power supply.
•
Attach an RS232 serial cable to the 9 pin connector on the back of
the power supply.
•
Plug the 9 pin connector into the serial port of a PC or work station.
Note : See Computer Interface manual for additional information.
Voltage
Requirements
Centering the
Spot Marker
COMPUTER
INTERFACE
ADJUSTMENTS