MX100E SIP-ISDN Gateway Series User Manual
New Rock Technologies, Inc. 1-3
# Mark
Description
③
STU
④
ALM
⑤
CON
A
configuration
interface.
⑥
ETH
Specifies an RJ45 module interface.
Interfaces ETH1 and ETH2 share the same IP address for allowing access to the external
network. Dual-LAN redundancy is supported.
⑦
AUX
An RJ45 interface.
Interfaces AUX1 and AUX2 share the same IP address for local management and
configuration.
⑧
T1/E1
An RJ45 interface, in support of 1 T1/E1, 2 T1/E1, and 4 T1/E1. Each T1 interface
supports the maximum 24 voice channels; each E1 interface supports the maximum 30
voice channels with ISDN PRI signalling.
⑨
SD
A SD card socket.
Table 1-2 Indicators
Mark Function
Status
Description
PWR
Power
Indication
Green Power
on
Off Power
off
STU
Status
Indication
Off
System locked and inactive
Green Flash
Normal operation
Red
System in the process of power up and not in the normal operation
mode
Red Flash
System in a diagnostic mode and able to execute limited operation
ALM
Alarm
Indication
Green No
alarms
Red Flash
New alarms occurred but not confirmed
Red
Alarms existed and all alarm information confirmed
ETH
Interface state
indicator
Long green
The link has been established but no service traffic is transmitted.
Blinking green
Service traffic is being transmitted on the link.
Off
The link is not established.
AUX
Interface state
indicator
Long green
The link has been established but no service traffic is transmitted.
Blinking green
Service traffic is being transmitted on the link.
Off
The link is not established.
T1/E1
Interface state
indicator
Long green
The connection works normally.
Blinking red
A remote alarm is generated.
Long red
A local alarm is generated.
Off
No connection is established.
Table 1-3 Pinouts of Ethernet Ports
RJ45
Pin-out
1 2 3 6
Description TX+
TX-
RX+
RX-