User Manual MX100E SIP-ISDN Gateway Series
5-6 www.newrocktech.com
Figure 5-4 SIP Configuration Interace
Table 5-4 SIP Configuration Parameters
Name Description
Signaling port
Configure the UDP port for transmitting and receiving SIP messages, with its default value
5060.
If the MX100E is connected directly to the Internet, it’s recommended to change the default
port value to prevent hacker attacks.
Note: The signaling port number can be set in the range of 1-9999, but cannot conflict with the
other port numbers used by the equipment.
Register server
Configure the address and port number of SIP register server, and the address and port number
are separated by “:”. The register server address can be an IP address or a domain name. When a
domain name is used, it is required to activate DNS service and configure DNS server
parameters on the page of configuring network parameters. For example: 201.30.170.38:5060,
register.com:5060.
Proxy server
Configure the IP address and port number of SIP proxy server, and the address and port number
are separated by “:”. The proxy server address can be set to an IP address or a domain name.
When a domain name is used, it is required to activate DNS service and configure DNS server
parameters on the page of configuring network parameters. Examples of complete and effective
configuration: 201.30.170.38:5060, softswitch.com:5060.
Backup proxy server
Configure the IP address and port number of backup proxy server. Add the address of calling
proxy server here, and the gateways can support selection function of multiple softswitch
addresses through IP address. The format must be IP address format and complete and effective
configuration, e.g. 202.202.2.202:2727. The proxy and register severs must be identical.
Conditions for falling over to the backup proxy server (any):
Gateway register is timeout.
No response to master server calls is timeout.
User name
Configure the user name as part of the account for registration.
Password
Password as part of account information is used for authentication by platform.
Password
Password as part of account information is used for authentication by platform.
Registration period
Valid time of SIP re-registration in second. Its default value 3600.
5.3.4 TDM Configuration
In case of full configurations, the MX100E has one 4T1/E1 card, with four interfaces numbering TDM1
to TDM4 from left to right. You are recommended to set parameters corresponding to the interface
configured. Parameters for each interface are identical. You can set different parameter values for each
interface as needed. For parameter setting, take the TDM1 as an example:
After login, click
Basic > TDM
tab to open the configuration interface.
