1 - GENERAL INFORMATION
Note to the owner
YANMAR CO., LTD. EMISSION CONTROL SYSTEM WARRANTY - USA ONLY
Your Warranty Rights and Obligations:
The California Air Resources Board (CARB), the United State Environmental Protection Agency (EPA) and YANMAR
CO., LTD. hereafter referred to as YANMAR, are pleased to explain the emission control system warranty on your
2016, 2017, or 2018 model year industrial compression-ignition engine. California-certified, new off-road compres-
sion-ignition engines must be designed, built and equipped to meet the State’s stringent anti-smog standards. In the
remaining forty nine (49) states, new non-road compression-ignition engines must be designed, built and equipped
to meet the United States EPA emissions standards. YANMAR must warrant the emission control system on your
engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of
your engine.
Your emission control system may include parts such as the fuel injection system, the air induction system, the elec-
tronic control system, EGR (Exhaust Gas Recirculation) system and the diesel particulate filter system. Also included
may be hoses, belts, connectors and other emission-related assemblies.
Where a warrantable condition exists, YANMAR will repair your off-road compression-ignition engine at no charge to
you including diagnosis, parts and labor.
Manufacturer’s Warranty Period:
2016, 2017, or 2018 model year off-road compression-ignition engines are warranted for the periods listed below. If
any emission-related part on your engine is found to be defective during the applicable warranty period, the part will
be repaired or replaced by YANMAR.
If your engine is
certified as
And its maximum
power is
And its rated
speed is
Then its warranty period is
Variable speed or
constant speed
Less than
19.0 kW
(
25.8 Hp
)
Any speed
1,500 hours or two (2) years whichever comes first. In
the absence of a device to measure the hours of use,
the engine has a warranty period of two (2) years.
Constant speed
19.0 – 37.0 kW
(
25.8 – 50.3 Hp
)
3000 RPM
or
higher
1,500 hours or two (2) years whichever comes first. In
the absence of a device to measure the hours of use,
the engine has a warranty period of two (2) years.
Constant speed
19.0 – 37.0 kW
(
25.8 – 50.3 Hp
)
Less than
3000 RPM
3,000 hours or five (5) years whichever comes first. In
the absence of a device to measure the hours of use,
the engine has a warranty period of five (5) years.
Variable speed
19.0 – 37.0 kW
(
25.8 – 50.3 Hp
)
Any speed
3,000 hours or five (5) years whichever comes first. In
the absence of a device to measure the hours of use,
the engine has a warranty period of five (5) years.
Variable speed or
constant speed
Greater than
37.0 kW
(
50.3 Hp
)
Any speed
3,000 hours or five (5) years whichever comes first. In
the absence of a device to measure the hours of use,
the engine has a warranty period of five (5) years.
Warranty Coverage:
This warranty is transferable to each subsequent purchaser for the duration of the warranty period. YANMAR recom-
mends that repair or replacement of any warranted part will be performed at an authorized YANMAR dealer.
Warranted parts not scheduled for replacement as required maintenance in the owner’s manual shall be warranted
for the warranty period. Warranted parts scheduled for replacement as required maintenance in the owner’s man-
ual are warranted for the period of time prior to the first scheduled replacement. Any warranted parts scheduled for
replacement as required maintenance that are repaired or replaced under warranty shall be warranted for the remain-
ing period of time prior to the first scheduled replacement. Any part not scheduled for replacement that is repaired or
replaced under warranty shall be warranted for the remaining warranty period.
During the warranty period, YANMAR is liable for damages to other engine components caused by the failure of any
warranted part during the warranty period.
1-11
Содержание Workmaster 25S
