New Holland 716736006, Руководство оператора, Страница: 8 / 20

8
1223
1
Figure 11
1. Nut
Side-to-Side Mower Leveling
The mower blades must be level from side to side. Check
the side-to-side level any time you install the mower or
when you see an uneven cut on your lawn. Before you
level the mower, set the air pressure in the front and rear
tires to 12 psi (.85 kPa).
3” to 4” (76-102 mm) Height-of-Cut Range
When the mower height-of-cut is set to the 3” to 4”
(76-102 mm) range the mower is suspended from the
tractor.
1. Park the tractor on a flat surface, disengage the power
take off (PTO), set the parking brake, and turn the
ignition key to “OFF” to stop the engine. Remove the
key.
2. Raise attachment lift lever all the way to the latched
position.
3. Carefully rotate blade(s) side to side (Fig. 12).
Measure between the outside cutting edges and the flat
surface (Fig. 12). If both measurements are not within
3/16” (5 mm), an adjustment is required; refer to steps
4 and 6.
Front
1
2
3
3
2
Figure 12
1. Blades side to side
2. Outside cutting edges
3. Measure here
4. Loosen adjustment bolt on one side and rotate hanger
bracket to raise or lower mower (Fig. 13).
5. After adjusting, tighten bolt and check side-to-side
level.
Important
If hanger is rotated to the end of
adjustment on one side and mower is not level, adjust the
opposite side.
1
2
1224
Figure 13
1. Bolt 2. Hanger bracket
6. Now check the front-to-rear blade slope; refer to
Front-to-Rear Blade Slope, page 9.
1-1/2”to 3” (38-76 mm) Height-of-Cut
Range
When the mower height-of-cut is set to the 1-1/2” to 3”
(38-76 mm) range the rear gage wheels contact the
ground. There is no side-to-side adjustment for this height
range, see Front-to-Rear Blade Slope.