New Holland 716736006, Руководство оператора, Страница: 5 / 20

5
3. Install link bracket between mower bracket and carrier
lift arm (Fig. 3).
4. Secure with 1/2” washers and 1” (26 mm) cotter pins
(Fig. 3).
2
1
3
4
m-4617
Figure 3
1. Link Bracket
2. Carrier lift arm
3. Washer 1/2”
4. Cotter pin 1” (26 mm)
5. Place adjustable links, with bolt heads down, between
brackets on the front of the mower (Fig. 4).
6. Secure to brackets with 1/2” washers and 1” (26 mm)
cotter pins (Fig. 4).
2387
1
2
4
3
1
4
3
Figure 4
1. Adjustable link
2. Bracket
3. Washer 1/2”
4. Cotter pin 1” (26 mm)
7. Place springs into brackets on mower with hooked
ends over raised back (Fig. 5).
8. Align grass deflector with holes in brackets and spring
straight ends in space under hinge and above deflector
(Fig. 5).
9. Secure deflector to bracket with 3/8–3-1/2 (89 mm)
bolts through grass deflector, springs and brackets.
Secure with 3/8” lock nuts (Fig. 5).
10. Lift grass deflector and check that it is spring loaded
and pivots freely to the full down position.
Important
Grass deflector must be spring loaded in
the down position. Lift deflector up to test that it snaps to
the full down position.
1
5
3
6
1783
4
2
Figure 5
1. Bracket
2. Spring hook end
3. space for spring
4. Grass deflector
5. Bolt 3/8–3-1/2” (89 mm)
6. Lock nut 3/8”
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator’s or
bystander’s direction and result in serious injury.
Also, contact with the blade could occur.
•
NEVER remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the mower.
•
Never try to clear discharge area or mower
blades unless you move the power take off
(PTO) to “OFF” and rotate the ignition key to
“OFF.” Also remove the key and pull the wire
off the spark plug(s).
Warning
Tractor Preparation
1. Park the tractor on a flat surface and lower attachment
lift to the full “DOWN” position. Refer to Operation:
Attachment Lift page 10.
Note: Turn Dial-A-Height control to allow lift to go to
full “MOUNTING” position.