New Holland 716736006, Руководство оператора, Страница: 16 / 20

16
2
1
2417
Figure 28
Top View
1. Idler spring 2. 5-1/2” (140 mm)
3. Install left and right pulley covers with previously
removed mounting screws.
4. Install the mower; refer to Installing the Mower,
page 6.
Power Take Off (PTO) Belt
Removing PTO Belt
1. Remove the mower; refer to Removing the Mower,
page 9.
2. Remove left pulley cover mounting screws and pulley
cover. Remove PTO belt (Fig. 29).
Installing the PTO Belt
1. Install the new belt around the blade pulley and the
idler pulleys.
2. Install left pulley cover with previously removed
mounting screws (Fig. 29).
3. Install the mower; refer to Installing the Mower, page
6.
4. Adjust belt guide so distance between belt and guide is
1/8” (4 mm) (Fig. 29).
m–2418
3
2
1
Figure 29
1. Left pulley cover
2. PTO belt
3. 1/8” (4 mm)
Storage
1. Clean dirt and chaff from the outside of the engine’s
cylinder head fins and blower housing. Also remove
grass clippings, dirt, and grime from the external parts
of the entire machine, especially the engine,
shrouding, and the top of the mower.
Important You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, lights, engine, and the battery.
2. Scrape heavy buildup of grass and dirt from the
underside of the mower. Then wash the mower with a
garden hose.
3. Check the condition of the blade(s); refer to Cutting
Blade, page 13.
4. Check the condition of the blade drive belt.
5. Grease the mower deck; refer to Greasing and
Lubrication, page 15.
6. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
7. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
8. Store the tractor in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it in
a memorable place. Cover the machine to protect it
and keep it clean.