New Holland 716736006, Руководство оператора, Страница: 6 / 20

6
2. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to “OFF” to stop the
engine. Remove the key.
3. Adjust transport height nut until bottom of rear lift
arms are approximately 7-1/4” (188 mm) from the
level surface (Fig. 6).
2
3
1
m-2399
Figure 6
1. Transport height nut
2. Rear lift arms
3. 7-1/4” (188 mm)
4. Raise attachment lift to the full “UP” position. Refer
to Operation: Attachment Lift page
5. Remove E-ring, washer and lift link from front lift arm
(Fig. 7).
6. Hold front lift arm up until stop contacts frame (Fig.
7).
7. Push back hard on lift rod, to raise linkage, and check
location of lift rod compared to mounting hole
location.
8. Adjust length of lift rod, by turning in\out of trunnion,
so end just slides into mounting hole in front lift arm
(Fig. 7).
9. Slide lift rod into hole and secure with previously
removed washer and E-ring (Fig. 7).
10. Check that stop is 0”–1/8” (0–3 mm) away frame
when fully assembled and lift in the full “UP”
position.
2
m–3398
4
1
3
5
Figure 7
1. E-ring
2. Washer
3. Stop on lift arm
4. Lift link
5. Trunnion
11. Remove bolts securing existing up-stop to tractor
frame (Fig. 8).
12. Place J-clip, holding drain hose, against frame and
mount new, long, up-stop to frame with previously
removed hardware (Fig. 8).
2
1
3
m-4622
4
Figure 8
1. Up-stop (long)
2. J-clip
3. Existing bolts
4. Ensure tab is in slot in
clutch
Installing the Mower
1. Park the tractor on a flat surface, disengage the power
take off (PTO), set the parking brake, and turn the
ignition key to “OFF” to stop the engine. Remove the
key.
2. Turn the front wheels straight ahead and raise
attachment lift lever all the way to the latched
position; refer to tractor Operator’s Manual.